Just put the firmware in your tftpd32 folder, run the software and select the server interface to serve. I'm using tftpd32 ( ) and the Chaos Calmer 15.05.1 firmware ( ). You have to run a TFTP server, to provide the firmware to your router. To enter the CFE prompt, you can press any key during the boot process, when the countdown stop message appears. Here you can the serial connection pins, on the left the GND, top right RX, bottom right TX). Summarizing it will be very simple, you just have to connect the router to a RS232 port, set the port at 115200 baud, no parity, 8bits and open your terminal software. The following steps may brick your device, so continue at your risk. The first step to start the game will be load the OpenWrt firmware. The following steps is needed only if your router hasn't OpenWrt on board.
0 Comments
Leave a Reply. |